ISO/TS TECHNICAL SPECIFICATION 15694 First edition 2004-04-15 Mechanical vibration and shock Measurement and evaluation of single shocks transmitted from hand-held and hand-guided machines to the hand-arm system Vibrations et chocs mécaniques - Mesurage et évaluation des chocs simplestransmisparlesmachinesportativesetguideesalamainau systeme mainbras Reference number ISO/TS 15694:2004(E) @ ISO 2004 ISO/TS 15694:2004(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ISO 2004-All rights reserved ISO/TS 15694:2004(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental, in liaison with Iso, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. In other circumstances, particularly when there is an urgent market requirement for such documents, a technical committee may decide to publish other types of normative document: of the parent committee casting a vote; committee and is accepted for publication if it is approved by 2/3 of the members of the committee castingavote further three years, revised to become an International Standard, or withdrawn. If the ISO/PAS or ISO/TS is confirmed, it is reviewed again after a further three years, at which time it must either be transformed into an InternationalStandardorbewithdrawn. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO/TS 15694 was prepared by the European Committee for Standardization (CEN) in collaboration with Technical Committee IsO/TC 108, Mechanical vibration and shock, Subcommittee SC 4, Human exposure to mechanical vibration and shock, in accordance with the Agreement on technical cooperation between isO and CEN (Vienna Agreement). Throughout the text of this document, read "...this European pre-Standard..." to mean "...this Technical Specification...". zalion'ghts reserved ii ISO/TS 15694:2004(E) Contents Page Foreword. Introduction. .vi 1 Scope. 2 Normative references. 3 Terms and definitions 4 Parameters for describing single shocks .. 4.1 Acceleration. 4.2 Flat.-weighted acceleration...... 2 4.3 Root-mean-squarevalueofflath-weightedacceleration 4.4 Running root-mean-square value of flath-weighted acceleration.. 4.5 Root-mean-quad value of flath-weighted acceleration