PD ISO/TR PUBLISHED DOCUMENT 18124:2006 Plastics piping systems - Multilayer M (metal) pipes Test method for strength of the weld line in the metal layer and bonding between layers by use of a cone ICS 23.040.20 BSi NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW British Standards PD ISO/TR 18124:2006 National foreword This Published Document is the UK implementation of ISO/TR 18124:2006. The UK participation in its preparation was entrusted to Technical Committee PRI/88/4, Test methods. A list of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard cannot confer immunity from legal obligations. Jan 2023. Version correct as of 2 Licensed copy: University of Oxford. This Published Document Amendments/corrigendaissued sincepublication was published under the authority ofthe Standards Policy and Strategy Date Comments Committee on 30 June 2009 CBSI 2009 ISBN9780580581014 PD ISO/TR 18124:2006 TECHNICAL ISO/TR REPORT 18124 First edition 2006-11-15 Plastics piping systems Multilayer M 12023 (metal) pipes Test method for strength Jan of the weld line in the metal layer and tasof25 bonding between layers by use of a cone correct Systemes de tuyauteries en plastiques - Tubes M (métal) multi-couches— Methode d'essai de la résistance de la ligne desoudureetducollageentrelescouchesenutilisantuncone Version f Oxford. d copy: University of Licensed Reference number ISO/TR 18124:2006(E) @ ISO 2006 PD ISO/TR 18124:2006 ISO/TR 18124:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In Jan 2023. s of 2 as ncorrect Version f Oxford. 0. d copy: University Licensed @ISO2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, ISO's member body in the country of the requester. ISO copyright office Case postale 56: CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii ISO2006-All rightsreserved PD IS0/TR 18124:2006 ISO/TR 18124:2006(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. IsO collaborates closely ywith the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote In exceptional circumstances, when a technical committee has collected data of a different kind from that informative in nature and does not have to be reviewed until the data it provides are co