ISO/TR TECHNICAL REPORT 17671-5 First edition 2004-05-15 Welding Recommendations for welding of metallic materials - Part 5: Welding of clad steels Soudage Recommandations pour le soudage des materiaux metalliques- Partie 5: Soudage des aciers plaqués Reference number ISO/TR 17671-5:2004(E) ISO Copyright International Organization for Standardization @ISO2004 itted without license from IHS Not for Resale ISO/TR 17671-5:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but should not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademarkof AdobeSystems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below @ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland yhematinalganzaionSandardizato @ISO2004-All rights reserved mittedwithout license from IHS Not for Resale ISO/TR 17671-5:2004(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the IsO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. In exceptional circumstances, when a technical committee has collected data of a different kind from that which is normally published as an International Standard ("state of the art", for example), it may decide by a simple majority vote of its participating members to publish a Technical Report. A Technical Report is entirely informative in nature and does not have to be reviewed until the data it provides are considered to be no longer valid or useful. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO should not be held responsible for identifying any or all such patent rights. ISO/TR 17671-5 was prepared by Technical Committee ISO/TC 44, Welding and allied processes, Subcommittee SC 10, Unification of requirements in the field of metal welding. welding of metallic materials: Part 1: General guidance for arc welding Part 2: Arc welding of ferritic steels Part 3: Arc welding of stainless steels Part 4: Arc welding of aluminium and aluminium alloys Part 5: Welding of clad steels Part 6: Laser beam welding Part 7: Electron beam welding ii Not for Resale ISO/TR 17671-5:2004(E) Introduction gRecommendations for welding of metallic materials Part 5: Welding of clad steel. Requests for official interpretations of any aspect of this Technical Report should be directed to the Secretariat of iSO/TC 44/SC 10 via your national standards body, a complete listing which can be found at www.iso.org. CoyrghteatinalganizationfStandardization @ISo2004-All rights reserved networking permited without lic