ISO INTERNATIONAL STANDARD 6443 Second edition 2005-10-15 Door leaves Method for measurement of height, width, thickness and squareness Vantaux de portes-Methodedemesurede lahauteur, lalargeur, I'épaisseuretl'equerrage Referencenumber ISO 6443:2005(E) @ISO2005 ISO6443:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please infom the Central Secretariat at the address given below. ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56·CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ ISO 2005 - All rights reserved ISO 6443:2005(E) Foreword IsO (the International Organization for Standardization)is a worldwide federation of national standards bodies (iSO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental, in liaison with IsO,also take part in the work. Iso collaborates closely y with the InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the IsO/lEc Directives, Part 2 adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval byat least 75%of thememberbodies casting avote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO6443wasprepared byTechnical CommitteeCEN/TC33,Doors,windows,shutters,buildinghardware Committee ISO/TC 162,Doors andwindows inparallelwith its approval bytheISO memberbodies This second edition cancels and replaces the first edition (iSO 6443:1980) which has been technically revised) Throughout the text of this document, read "... this European Standard .." to mean ".. this International Standard...". @ ISO 2005 - All rights reserved ili ISO6443:2005(E) Page 2 EN 951:1998 Foreword This European Standard has been preparedby Technical Committee CEN/TC 33"Doors, windows, shutters and building hardware", the secretariat of which is held by AFNOR. ThisEuropeanStandardreplacesEN25:1975. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by June 1999, and conflicting national standards shall be withdrawnat the latestbyDecember 1999. This standard is one of a series of standards for doors. The test method relates to performance requirements to be published in EN 1529. According totheCEN/CENELEC InternalRegulations,the national standards organizationsof the following countries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland, France,Germany,Greece,Iceland, Ireland, Italy, Luxembourg Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. iv ISO 2005 - All rights reserved ISO 6443:2005(E) Page 3 EN951:1998 Scope This European standard applies to all rectangular door leaves and the measurable parameters of doors of other shapes. This standard specifies the method to be used to measure the dimensions of height, width and thickness, and defects of squarene