ISO INTERNATIONAL STANDARD 7650 First edition 1987-08-01 AMENDMENT1 2001-08-15 Commercial vehicles and buses Mounting dimensions for starter motors of types 1, 2, 3 and 4 AMENDMENT 1 Vehicules utilitaires et autobus -- Dimensions de montage des demarreurs de types 1, 2, 3 et 4 AMENDEMENT1 Referencenumber ISO 7650:1987IAmd.1:2001(E) so @ISO2001 IS07650:1987IAmd.1:2001(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shail not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or iso's member body in the country of the requester. ISO copyright office Case postale 56·CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 4122 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland Coovriani international Oraanization for Standardization @ Is0 2001 - All rights reserved IS07650:1987/Amd.1:2001(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (Iso committees. Each member body interested in a subject for which a technical committee has been established has liaison with isO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 3 Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Attention is drawn to the possibility that some of the elements of this Amendment may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. Amendment 1 to International Standard ISO 7650:1987 was prepared by Technical Committee ISO/TC 22, Road vehicles, Subcommittee sc 15, Interchangeability of components of commercial vehicles and buses.