ISO INTERNATIONAL STANDARD 19064-1 First edition 2015-11-15 Plastics - Styrene/acrylonitrile (SAN) moulding and extrusion materials - Part 1: Designation system and basis for specifications Plastiques - Styrene/acrylonitrile (SAN) pour moulage et extrusion - Partie 1: Systeme de désignation et base de spécification Reference number IS0 19064-1:2015(E) ISO International Organization for Standardization @ IS0 2015 HEJIANG INST OF STANDARDIZATION C15956617 IS0 19064-1:2015(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2015, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Intenatinair PrganizationforStandardization ensee-ZHEJIANG INSTOF STANDARDIZAoISQ15- All rights reserved etworking permitted without license from IHS IS0 19064-1:2015(E) Contents Page Foreword ..iv Introduction. 1 Scope.. 2 Normative references 3 Designation system .2 3.1 General 2 3.2 Data block 1 3.3 Data block 2 .3 3.4 Data block 3 .3 3.5 Data block4 4 3.5.1 Vicat softening temperature ..4 3.5.2 Melt mass-flow rate. .5 3.6 Data block 5 .5 4 Examples of designations 5 Inteatinal oganzation @st(Sr20.1.5- All rights reserved iii See=ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS under ed without license from IHS Not for Resale, 2016/1/8 01:57:05